Corvette Yellow Base Coat 2 Quart or 2 Gallon Kit

From: $59.99

2 Quart Kit – 1 quart of basecoat color, 1 quart of Reducer

2 Gallon Kit – 1 Gallon of basecoat color, 1 gallon of Reducer

Excel Corvette Yellow Base Coat Series is a quick dry, good hiding, factory pack line of many popular colors. Various OEM colors are available. Ideal for overalls, large blend are repairs, or for ground-coat material.

TECH SHEET

MSDS

Clear

Your personal data will be used to process your order, But will never be SHARED with anyone We value your privacy. privacy policy.

Description

Excel Corvette Yellow Base coat

DOES NOT SHIP OVERSEAS OR TO CALIFORNIA

This is a quick dry, good hiding, factory pack line of many popular colors. Various OEM colors are available. Ideal for overalls, large blend area repairs, or for ground-coat material. For a complete and current list of colors offered, please visit www.excelproducts.net Application Surface Preparation For dry sanding, a final sanding step of P500-P600 grit is reccomended using a maximum 100 grit step difference or less throughout the taken sanding steps. For wet sanding, a final sanding step of P800-P1000 grit is recommended using a maximum of 200 grit step difference or less throughout the sanding steps. Clean area with a good grade wax and grease remover such as #91001 and wipe dry with a clean cloth. Wipe area with tack cloth to remove any dust or dirt particles. Mixing Directions • 2 Part Excel Basecoat • 1 Part Excel Urethane Reducer • Spray Gun Set-up • Spray Gun: Fluid tip: Application pressure: • Compliant Gravity feed 1.3-1.5mm 30 PSI at the spray gun air inlet • Gravity feed HVLP 1.3-1.5mm 10 PSI max at air cap • Siphon feed 1.6-1.8mm 40-50 PSI Application Apply 2 – 4 single coats or until full coverage is achieved. Drying Schedule Allow each coat to flash off for approximately 5 to 10 minutes at 70°F. Prior to clear coat application, allow a minimum of 20 minutes flash time at 70°F and a maximum of 24 hours flash time at 70°F. Should this maximum time be exceeded, scuff surface and apply another coat.

Cleaning of Equipment: Clean equipment with lacquer thinner.

Technical Data

  • Mixing Ratio 2:1 by vol. w/reducer
  • Pot life Indefinite, if not catalyzed
  • Viscosity @ Gun 13 – 15 sec #4 Zahn
  • Recommended Film Thickness Approx. 0.4 – 0.8 mil
  • Flash Point 53°F TCC
  • Air Pressure @ Gun 30 PSI gravity feed,
  • 10 PSI max at cap HVLP, 40-50 PSI siphon feed
  • Coverage @ 0.6 mil 286 sq ft/g
  • VOC @ Gun Maximum of 6.8 lb/gal in ready to spray form

Additional information

Reducer Drying Speed

Fast, Medium, Slow

Amount

2 QUART KIT, 2 GALLON KIT

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.