Toyota Super White Basecoat QUART or GALLON KIT

From: $64.99

  • Makes a perfect basecoat for any of our pearls.
  • Jet Black Basecoat is a direct replacement for PPG DBC 9700
  • Choose a reducer speed for the right painting temperature (Fast=cold, Slow=Hot)
Clear
Browse Wishlist
SKU: N/A Category:

Description

Toyota SUPER WHITE BASECOAT (cross-reference PPG DBC9700)

Description:

Toyota Super White Basecoat is used in the DBU basecoat systems. Super white Basecoat is available in an F-style gallon and a round quart.

Can be used with:

Fast Urethane Reducer

Medium Urethane Reducer

Slow Urethane Reducer

Ex-Slow Urethane Reducer

APPLICATION: Apply 2-3 medium wet coats or until proper hiding is achieved. Allow 5-10 minutes flash time between coats.

Excel Basecoat Series is a quick dry, good hiding, factory pack line of many popular colors. Various OEM colors are available. Ideal for overalls, large blend area repairs, or for ground-coat material. For a complete and current list of colors offered, please visit www.excelproducts.net Application Surface Preparation For dry sanding, a final sanding step of P500-P600 grit is recomended using a maximum 100 grit step difference or less throughout the taken sanding steps. For wet sanding, a final sanding step of P800-P1000 grit is recommended using a maximum of 200 grit step difference or less throughout the sanding steps. Clean area with a good grade wax and grease remover such as #91001 and wipe dry with a clean cloth. Wipe area with tack cloth to remove any dust or dirt particles. Mixing Directions • 2 Part Excel Basecoat • 1 Part Excel Urethane Reducer • Spray Gun Set-up • Spray Gun: Fluid tip: Application pressure: • Compliant Gravity feed 1.3-1.5mm 30 PSI at the spray gun air inlet • Gravity feed HVLP 1.3-1.5mm 10 PSI max at air cap • Siphon feed 1.6-1.8mm 40-50 PSI Application Apply 2 – 4 single coats or until full coverage is achieved. Drying Schedule Allow each coat to flash off for approximately 5 to 10 minutes at 70°F. Prior to clearcoat application, allow a minimum of 20 minutes flash time at 70°F and a maximum of 24 hours flash time at 70°F. Should this maximum time be exeeded, scuff surface and apply another coat. • Cleaning of Equipment • Clean equipment with lacquer thinner

Additional information

SIZE

GALLON KIT, QUART KIT

REDUCER SPEED

SLOW, MEDIUM, FAST

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.